|
How to Perform Disk Error Checking in
Windows XP
Microsoft Knowledge Base Article: 315265
- This article describes how to check
the integrity of the hard disk drive
in Windows XP. After you install Windows
XP, the Scandisk command is not
available.
How to Perform
Scandisk in Windows
Microsoft Knowledge Base Article: 156571
- After you install Windows, there is
no scandisk command in the System tools
folder.
CHKNTFS.EXE:
What You Can Use It For
Microsoft Knowledge Base Article: 160963
- The Chkntfs.exe utility has been developed
by Microsoft and is available in Microsoft
Windows NT 4.0 Service Pack 2 and later
versions of Windows. It is designed
to disable the automatic running of
chkdsk on specific volumes, when Windows
restarts from an improper shutdown.
Chkntfs can also be used to unschedule
a chkdsk if chkdsk /f was used to schedule
a chkdsk on an active volume on the
next system restart.
An Explanation
of the New /C and /I Switches That Are
Available to Use with Chkdsk.exe
Microsoft Knowledge Base Article: 314835
- This article describes two new switches,
the /C switch and the /I switch,
that are included in the CHKDSK program
in Windows XP. These switches enable
better management of the downtime that
occurs when you run CHKDSK or AUTOCHK
|
